Shopping Cart
Propane Gas Refrigerartors and off grid appliances
Propane Refrigerators and off grid appliances

9 reasons to choose Dynamx for gas fridge and propane gas appliances

$50 Cash award program for going with Dynamx gas appliances

our commitment at Warehouse Appliance for gas fridge and gas appliances

Get a shipping Quote for a propane appliance

Scratch N dent discounted gas refrigerators

How to build a manometer

How To Test Gas Pressure

Manometer to test LPG pressure

Although most gas appliances are not sensitive to slight gas pressure variations, performance of a gas refrigerator is very dependent upon the correct gas pressure. Checking the gas pressure should always be a part of a any gas fridge maintenance program or gas refrigerator repair. We suggest to have your gas supplier check your gas pressure or do it yourself with the below instructions.

Parts needed;

Approximately 60" of clear 3/8" flexible plastic (vinyl) tubing.

Staples or tie straps to hold tubing to back plate.

6" x 16" wood board or sheet metal.


1.) Attach the plastic tubing to the back board using staples or tie straps in a "U" shape 12" to 14" in both directions as per the below drawing.

2.) At about the midway point of the tubing, mark the back board with a zero location.

3.) From the zero location, place marks every 1/2" above and below. Number the marks every one inch. Place a target arrow mark at 5 1/2" on top and bottom. This target will equal 11 inches of water column (W.C.).Monometer to test gas pressure


To test gas pressure;

1.) Fill the Manometer "U" tubing with water until both sides reach zero.

2.) Connect free end of tubing to the gas supply line. A slip fit or hand held fit should be sufficient. Be sure it does not leak.

3.) Hold the Manometer vertical and slowly turn the gas supply on.

4.) The pressure will push the water down the input side and up the output side. The combined sum of both distances is the "inches of water column pressure". The target is 5 1/2" + 5 1/2" = 11 inches of W.C.

5.) Most high quality regulators will have an adjustment screw usually covered with a plug or plastic screw cap. Turn the adjuster screw slightly and repeat steps 3 & 4 until 11" W.C. is achieved.




Posted to: Gas Appliance, Solar Products, and Absorption Refrigeration Information and Articles


All Blog Posts



Dynamx inc on facebookDynamx inc on twitterDynamx inc on google+Dynamx inc on youtubeDynamx inc on pinterestDynamx inc on tumblrDynamx inc on blogger
Dynamx inc on facebook Dynamx inc on twitter Dynamx inc on google+ Dynamx inc on youtube Dynamx inc on pinterest Dynamx inc on tumblr Dynamx inc on blogger